K-2 PICKLING PASTE (GEL FORM)

We Love Staying Connected

Surface Innovators LLP - Makers of K-2

Surface Innovators LLP

K-2 Pickling Paste

K-2 Pickling Paste

Description

K-2 Paste is used to clean weld seams and the areas surrounding the welds.

AREA COVERED

K-2 Paste form covers 90-100 meters of weld seams with 1kg. Of chemical.

APPLICATION PROCEDURE FOR K-2 PASTE

• Add 50gms of SI. 56 Degreaser to 1 ltr. Of water (5% w/v.). Apply solution on the surface for 10-15minutes & then wash thoroughly and allow the surface to air dry.
• K-2 Paste is to be applied on the weld seams and surrounding area with a brush.
• Leave the K-2 Paste on the weld seams for 30-45 minutes depending on the thickness of the oxide scale.
• Brush the surface with a plastic bristled brush and then wash surface thoroughly with high pressure water and allow the surface to air dry.
• Next apply K-2 Passivation solution and leave it for 20-25minutes.
• Finally clean the surface thoroughly with demineralised water and dry.

Note:

Chloride content in rinse water should be less than 50ppm.

Shake the products well before use.

Do not apply the products on the SS Surface under direct sunlight.

K-2 Passivation is a must after every pickling process.